Highsider Can-Bus CBW1 Resistor 207-033

Highsider Can-Bus Resistor CBW1 With Dip-switch.

Our Newly Developed Highsider Can-Bus Resistor CBW1 Fits Most Vehicles That Have a Can-Bus System.

The CBW1 Resistor Provides A Required Electrical Load for Your Vehicle, Which, if the dip switches are set correctly, will result in no flashing of the accessory flashlers in the cockpit.

In addition, a reliability is given. This Means:
If the Accessory Indicators Fail Due to an Electronic Fault, an Error Message is immedialy displayed in the cockpit.

Up to 2 Channels Can Be Operated, Such as Turn Signals at the Rear Left and Turn Signals at the Rear Right.

IF 2 Pairs of Indicators Need to Be Changed, Also 2 CBW1 Needed to Be Used.

Which Requirements Should Be Met In order to use the cbw1 on the motorbike:

The Motorbike was original produced with LED Indicators or the Motorbike has a can-bus system

If these requires are not met, the cbw1 unit will not function (!) In this case, we recommend the following resistances:

For Indicators With 21 Watt:
6.8 Ohm Partnumber 1108546002 or 10 ohm partnumber 1108546004

For Indicators with 10 watts:
27 Ohm Partnumber 1107562

The Following Resistance Values ​​Can Be Set On The CBW1:

• 150 ohms
• 170 ohms
• 240 ohms
• 300 ohms
• 400 ohms
• 600 ohms
• 1200 ohms

Dimensions:
Height = 11mm
Width = 31mm (Without Straps)
Width = 46mm (with tabs)
Length = 40mm

Cable Length = 200mm With Pins

Connections:
Yellow = Input Channel 1 (+)
Orange = Output Channel 1 (+)
Blue = Input Channel 2 (+)
Red = Output Channel 2 (+)
Gray = Input Mass (-)
Black = Output Ground (-)

Hints:
- Up to 2 Channels Can Be Operated.
- The Connection is Explained precious in the mounting instructions!